VIAIR 10005 Heavy Duty OBA For up to 35" Tires – 150 PSI / 2.62 CFM

VIAIR’s Heavy Duty Onboard Air System is a pre-packaged compressed air solution that provides a faster 33% duty cycle 400C compressor, 2.5 gallon air tank, and all components needed to install a working system capable of inflating tires right out of the box.

Please Note: Pressure Switch w/Relay (PNs 90110, 90111, 90113, 90118) is not a sealed unit and should be installed in an area protected from the elements to prevent damage and/or failure.

Use thread sealant for proper installation. Thread tape is not recommended. Properly sealed, recommended torque for 1/8? is 10 ~ 11 ft. lbs. Recommended torque for 1/4? and 3/8? is 12 ~ 15 ft. lbs.

FEATURES
– 2.5 Gallon VIAIR Air Tank
– 400C VIAIR Compressor w/Thermal Overload Protector
– 35ft. Coil Hose with Tire Chuck
– 1/4” Quick Connect Stud (F)
– 1/4” Quick Connect Coupler (F)
– Dash Panel Gauge with ON/OFF Switch
– Pressure Switch with Relay (110 PSI on, 145 PSI off)
– Reducer: 1/8” (F) to 1/4” (M)
– 1/4” 175 PSI Safety Valve
– 1/4” Drain Cock
– (3) 1/4” Compression Fittings
– 20ft. 12-Gauge Wire with Inline Fuse Holder
– 4” Strip of Continuous Grommet Material
– Accessory Airline
– Electrical Connections

SPECIFICATIONS
– 12-Volt
– Permanent Magnetic Motor
– Duty Cycle: 33% @ 100 PSI
– Max. Working Pressure: 150 PSI
– 1/4” Quick Connect Coupler (F)
– Max. Amp Draw: 28 Amps
– Ingress Protection Rating: IP67

All Fittings are NPT rated unless otherwise noted.
Wiring harness NOT included.